Fujitsu PRIMERGY BX900 - Page 719

© 2011 Fujitsu Technology Solutions
717
10.16.4.4 radius-server retransmit
This command sets the maximum number of times a request packet is re-transmitted when no response is
received from the RADIUS server. The retries value is an integer in the range of 1 to 15.
Syntax
radius-server retransmit <retries>
no radius-server retransmit
<retries> - the maximum number of times (Range: 1 - 15).
no - This command sets the maximum number of times a request packet is re-transmitted, when no
response is received from the RADIUS server, to the default value, that is, 10.
Default Setting
10
Command Mode
Global Config
10.16.4.5 radius-server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted to the
RADIUS server if no response is received. The timeout value is an integer in the range of 1 to 30.
Syntax
radius-server timeout <seconds>
no radius-server timeout
<seconds> - the maximum timeout (Range: 1 - 30).
no - This command sets the timeout value (in seconds) after which a request must be retransmitted to
the RADIUS server if no response is received, to the default value, that is, 6.
Default Setting
6
Command Mode
Global Config