© 2011 Fujitsu Technology Solutions
802
10.21.2.4 pin-group repin-timer
To configure the repining timer to allow the repining process occurred after a delay of time when a uplink
port is link up. Use “no pin-group repin-timer” to restore the default setting.
Syntax
pin-group repin-timer <10-60>
no pin-group repin-timer
<10-60> - The delay between the link up of a link and pinning. The value is range from 10 to 60
seconds.
no – Restore the default timer.
Default Setting
10 seconds
Command Mode
Global Config
To Next Page
Loading...
