6 LEDs 81
E
There is a problem with the cartridge that is
being loaded or that has just been ejected.
Insert the cartridge again. If this problem
occurs again there is something wrong with
the cartridge. Replace the damaged
cartridge with a new data cartridge.
In the case of a cleaning cartridge the
maximum number of times it can be used
has been exceeded. Replace the cleaning
cartridge with a new one.
The following status
occurs when the
cartridge is ejected
right after insertion.
The following status
occurs straight
cartridge is ejected.
It is possible that an error has occurred in
the memory of the inserted cartridge.
If the cartridge is prohibited from
performing write operations data can be
read by inserting the cartridge. After the
data has been restored do not use this
cartridge again.
A error has been detected. Insert a new cartridge and check if this
solves the problem. If this does not solve
the problem restart the server.
There is a problem with the firmware
download.
This problem will not occur during normal
operations. If this occurs at any other time
than when firmware is being rewritten
insert the cartridge and check if the
problem has been solved. If this does not
solve the problem restart the server.
*LEDs turn on
alternately and
repeatedly.
A firmware error has occurred. Restart the server.
LED Status Problem Solution
Ready
Drive Error
Tape Error
Clean
Ready
Drive Error
Tape Error
Clean
Ready
Drive Error
Tape Error
Clean
Ready
Drive Error
Tape Error
Clean
Ready
Drive Error
Tape Error
Clean
Ready*
Drive Error*
Tape Error*
Clean*
To Next Page
Loading...
