350 Upgrade and Maintenance Manual RX2530 M4
14.3.1.3 Installing the front VGA board
Figure 261: Installing the front VGA board
Ê Push the front VGA connector in the corresponding recess (1) and fasten the
front VGA board with two screws (2).
Ê Route the cable tie under the front VGA board (3).
14.3.1.4 Concluding steps
Ê "Installing the front panel module" on page 346
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 63
Ê "Switching on the server" on page 66
14.3.2 Removing the front VGA board
14.3.2.1 Preliminary steps
Ê "Shutting down the server" on page 49
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH1 / (+) No. 1 screw driver
To Next Page
Loading...
