Ê Insert ServerView Suite DVD in the DVD drive.
Ê Follow the on-screen instructions (see also section "Configuring the
server and installing the operating system with the ServerView
Installation Manager" on page 79 or section "Configuring the server and
installing the operating system without the ServerView Installation
Manager" on page 80).
– Operating system already installed:
Ê Press the On/Off button.
The server is switched on, performs a self test and starts loading the
operating system.
I In the case of configurations with a large memory size, the boot
process may be prolonged and the screen may remain dark for
several minutes.
Switching the server off
The Power-on indicator (see figure 10 on page 63, figure 11 on page 63 and
figure 12 on page 64) lights up green.
Ê Shut down the operating system properly.
The server is switched off automatically. The AC connected indicator lights up
green.
I If the operating system does not switch off the server automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal for power button override.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S4, you can configure
that the server is switched on/off controlled by an internal timer.
– Ring indicator
The server is switched on by an internal or external modem.
To Next Page
Loading...
