Fujitsu PRIMERGY RX4770 M5 - Page 211

Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
When replacing network controllers, network configuration settings in
the OS will be lost and replaced by default values. This applies to all
static IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing a
controller
.
Preliminary steps
▶
If applicable, "Note on network settings recovery" on page
211.
▶
"Locating the defective server" on page 43
▶
"Suspending BitLocker functionality" on page 85.
▶
If applicable,"Disabling the boot watchdog" on page 86.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 47.
▶
"Locating the defective component" on page 44.
▶
For slot 3, 4, 5, 6 and 7: Remove the corresponding riser module, see
"Handling riser modules" on page 60.
Removing the defective expansion card
▶
Remove the expansion card, see "Removing the expansion card" on
page 209.
▶
If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see "Removing a slot bracket" on page 173.
Expansion cards and backup units
RX4770 M5 Upgrade and Maintenance Manual 211