RX600 S5 Operating Manual 111
CSS components Hot-plug components
Removing engaging hooks
Figure 30: Removing engaging hooks from the removal tool
Ê Push the green engaging hooks down in the direction of the arrows (1) until
they disengage from the removal tool.
Ê Remove the engaging hooks (2) and keep them in a safe place.
Ê To insert a new expansion card, continue with section "Installing a hot-plug
expansion card" on page 113.
V CAUTION!
If you remove an expansion card and do not insert a replacement, you
will have to use a dummy module for better cooling, to comply with
applicable EMC regulations (regulations on electromagnetic
compatibility) and to protect against fire. Ensure that the dummy module
engages correctly in the slot.
//
/
000
To Next Page
Loading...
