RX600 S5 Operating Manual 113
CSS components Hot-plug components
Ê Take the retaining plate out and put it aside.
I Keep the retaining plate for future use.
Ê Push the engaging hooks down until they disengage from the removal tool
(see figure 30 on page 111), and keep them in a safe place.
8.1.4.4 Installing a hot-plug expansion card
Inserting an expansion card in the removal tool
Figure 32: Inserting the new expansion card in the removal tool
Ê Insert the new expansion card in the provided slot (see oval in figure above)
of the removal tool.
Ê Insert the green engaging hooks (see circles in figure 32 on page 113) in the
rods and push them down until they engage in the upper edge of the
expansion card.
V CAUTION!
Make sure that e.g. the ports on the expansion card are not blocked
by the engaging hooks.
To Next Page
Loading...
