En-13
SWING OPERATION
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) for three seconds
on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 2) for three seconds.
● When the air conditioner is operated by
the controls on the Main Unit, it will oper-
ate under the same mode as the AUTO
mode selected on the Remote Controller
(see page 7).
● The fan speed selected will be “AUTO”
and the thermostat setting will be stand-
ard (24
°C).
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 5 Q).
The SWING Display (Fig. 6 Y) will light.
In this mode, the Air ow Direction Louvers will swing automatically to direct the air ow
both up and down.
To stop SWING Operation
Press the SWING button (Fig. 5 Q) once again.
The SWING Display (Fig. 6 Y) will go out.
Air ow direction will return to the setting before swing was begun.
About Swing Operation
During cooling/Dry mode : Swings between 1 and 3.
During heating mode : Swings between 3 and 6.
● The SWING operation may stop temporarily when the air conditioner’s fan is not operating,
or when operating at very low speeds.
To Next Page
Loading...
