Replacing the Pick Roller
415
11.Attach the sheet guide.
Hold the squeeze clips on both sides, and attach the sheet guide.
It clicks when the squeeze clips are released.
12.Close the ADF top section.
Slide the side guides all the way, and pull the sheet guide open from the dip.
It clicks when it returns to its original position.
13.Connect the power cable to the AC outlet or the USB bus power cable,
and turn on the ScanSnap.
14.Reset the consumable counter.
ATTENTION
Confirm that the sheet guide is attached properly. Otherwise, paper jams or other feeding errors may
occur.
Squeeze clip
Sheet guide
Squeeze clip
ADF top section
ADF paper chute
(cover)
To Next Page
Loading...
