Fujitsu ScanSnap SV600 - Automatic Power off

Automatic Power OFF
When the ScanSnap is turned on and left unused for the specified time (default is "4 hours"), it will
turn itself off automatically.
To turn the ScanSnap back on, perform one of the following operations:
l Press the [Scan] button on the ScanSnap (this will not start scanning)
l Press the [Stop] button on the ScanSnap
HINT
l To continue using the ScanSnap, reset the time until auto power-off by pressing the [Scan] button
on the ScanSnap.
l You can change the time of the ScanSnap to turn off automatically or change the setting so that it
will not turn off automatically. Set according to the following procedures:
1. Click the ScanSnap Manager icon
in the Dock while holding down the [control] key on the
keyboard, and then select [Preferences] from the "ScanSnap Manager Menu" (page 41).
a The [ScanSnap Manager - Preferences] window appears.
2. In the [Power] list, change the settings for [Power setting] based on how it is connected.
l A notification window notifies you 5 minutes before the ScanSnap turns off automatically.
Turning the ScanSnap On or Off
51