Fujitsu SCENIC S - Connecting the PC to the Electricity Supply

Connecting the PC to the electricity supply Preparation for use and operation
A26361-K523-Z100-6-7619 13
Connecting the PC to the electricity supply
1
1 = Notch for inserting the screwdriver
Ê Check the voltage setting.
!
The value shown or the value marked with an arrow be compatible with the local
electricity supply:
115 = 100 V to 127 V 230 = 200 V to 240 V
If the voltage setting is incorrect:
Ê Lift out the manual voltage adjuster with a screwdriver (1), turn it to the required setting and
replace it.
1
2
Ê First connect the power cable to the PC (1) and then to the mains supply (2).