System expansions
40 A26361-K523-Z100-6-7619
Compact flash board
If your PC is used as a Thin Client, the operating system Linux and the Thin Client software is
installed on the compact flash board. The compact flash board is equipped with an IDE interface
and is mounted in the PC on the side of the drive cage. The BIOS treats the compact flash board as
though it were an IDE hard disk.
Installing the compact flash board
Ê Open the casing (see "Opening the casing“).
1
2
Ê Undo the screw (1).
Ê Lift the carrier out of the casing (2).
2
2
CS
S
M
Ê Slide the compact flash board into the holder with the component side facing the carrier (1).
Ê Fasten the board into place with the screw (2).
Ê Plug the jumper into position "M" if necessary ("Master" setting).
To Next Page
Loading...
