System expansions
A26361-K523-Z100-6-7619 53
Installing a hard disk drive
Ê Take the new hard disk drive out of its packaging.
Ê Make the required settings (e.g. master-slave settings) on the drive.
i
If your computer has a compact flash board, you must set the hard disk up as a slave.
2
Ê Slide the hard disk drive into the drive carrier (1).
Ê Fasten the drive into place with the screws (2).
Installing the hard disk carrier
Ê Fit the data and power supply connectors to the hard disk drive or to the hard disk drives.
Ê Lift the hard disk carrier into the casing (in the direction shown by the arrow) and push it
forward until it engages.
Ê Install the drive carrier again (see "Installing an accessible drive").
Ê Close the casing (see "Closing the casing“).
To Next Page
Loading...
