Chapter 4 FRU Removal Preparation 4-43
11. Fasten the cables running along the left route to the cable holder with a short
hook-and-loop fastener. (See (9) in
FIGURE 4-15.)
12. Bind each remaining bundle of hanging cables with a short hook-and-loop
fastener. (See (10) in
FIGURE 4-15.)
13. Also bind each of these bundles of cables with a short hook-and-loop fastener
at a location near the floor panel. (See (11) in
FIGURE 4-15.)
Binding the cables near the floor panel facilitates cable handling through floor
panel openings.
FIGURE 4-15 Magnified View of Part C (M8000, rear view)
To Next Page
Loading...
