24-12 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
FIGURE 24-8 Mounting the PSU (Front of the M8000)
10. Connect power cords to the added rack-mountable dual power feed unit.
11. Switch on all main line switches for AC section (ACS) of both power supply
systems.
12. Confirm that the XSCF STANDBY LED (green) on the operator panel remains
lit. If it is blinking, wait until it remains lit.
13. Start (turn on power) all domains together. Take either of the following two
actions:
■ Press and hold down (for less than four seconds) the POWER switch on the
operator panel.
To Next Page
Loading...
