Fujitsu SPARC Enterprise M9000 - Page 542

Index-2 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
IOU, 7-17
MEDBP, 22-5
OPNL, 10-4
PCI, 13-20
PSU, 9-12
PSU BP, 20-1
servers BPs, 20-1
SNSU, 21-4
SWBP, 23-5
TAPEU, 15-9, 15-11
XBU, 17-4
XSCFU, 11-12
commands for checking hardware configuration and
status, 2-24
commands for checking the messaging output, 2-30
commands for checking the monitoring output, 2-29
component, B-1
components to access and doors to open, 5-2
Conditions of memory mount, 6-40
confirming the hardware, 4-7, 4-15, 4-20
corresponding components and doors that can be
accessed, 5-2
CPU and DIMM replacement, 6-29
CPU memory board unit, B-4
CPU module, B-5
crossbar unit, B-14
crossbar unit replacement, 17-1
D
DDC, B-37
active replacement, 19-3
cold replacement, 19-7
DDC replacement, 19-1
devices, 2-38
diagnostic method flow chart, 2-22
diagnostics methods, 2-21
DIMM replacement, 6-44
disconnecting
CMU/IOU, 4-3
FRU from a domain, 4-3
PCI card, 4-4
disconnecting and replacing a FRU, 4-5
disconnecting off and replacing a FRU, 4-12
doors, how to open and close, 5-1
downloading the error log information, 2-26
E
error conditions, 2-26
error display by LED, 2-30
EZ label, 2-12
F
FAN
active replacement, 8-8
cold replacement, 8-14
hot replacement, 8-8
FAN backplane, B-39
fan BP
cold replacement, 20-1
FAN unit, B-30
FAN unit replacement, 8-1
fmadm config command, 2-35, 2-36
fmadm faulty command, 2-35
fmadm repair Command, 2-36
fmdump command, 2-35
fmstat command, 2-37
FRU removal preparation, 4-1
FRU status, 2-23
FRU, disconnecting from a domain, 4-3
FRU, incorporating into a domain, 4-6
G
Grounding Port Connection Locations, 1-11
H
hard disk drive, B-10
hard disk drive (HDD) replacement, 12-1
hardware configuration, 2-23
HDD
active replacement, 12-3
cold replacement, 12-5
hot replacement, 4-2, 4-12
CMU, 6-12
FAN, 8-8
IOU, 7-8
PCI, 13-17
PSU, 9-8
how to open and close doors, 5-1
how to remove a door, 5-3
how to remove a side panel, 5-4