► Disconnect both WWAN antenna cables (red circles) from the LTE module.
► Remove the M2XL2.5-0 screw (yellow circle).
► Now the LTE module is loose and can be removed by slightly increasing its inclination in the direction of the blue arrow.
Warning!
► The antenna cables are routed through a cable duct into the camera module (yellow arrow).
► Please put the antenna cables in their original positions when reassembling.
Please note!
When fitting the LTE module, make sure that both antenna cables are properly connected.
The yellow cable must be connected to the “MAIN” port and the orange one to the “AUX” port.
(yellow -> MAIN; orange -> AUX)
Return to Table of Contents
To Next Page
Loading...
