Fujitsu STYLISTIC Q7310 - Removing the Rear Camera

Page 30 of 64
Removing the rear camera
Required work steps:
■ Remove keyboard
■ Remove cradle
■ Remove pen
■ Removing the LCD back cover assy
■ Remove battery
■ Remove LTE module
■ Remove the camera module
Required tools:
■ Screwdriver: Phillips, size PH00
► The module of the rear camera is connected with a flexprint cable on the sub board of the camera module (yellow rectangle).
Disconnect this cable and run the rear camera module out of the module (green arrow).
Return to Table of Contents
Service Partner only