EasyManua.ls Logo

Fujitsu STYLISTIC Q7310 - Removing the Fingerprint Sensor

Fujitsu STYLISTIC Q7310
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 40 of 64
Removing the fingerprint sensor
Required work steps:
Remove keyboard
Remove cradle
Remove pen
Removing the LCD back cover assy
Remove battery
Required tools:
Screwdriver: Phillips, size PH00
Please observe this information when you use the fingerprint sensor!
The figure above shows a device configuration with fingerprint sensor (yellow rectangle).
When the fingerprint sensor is used, the fingerprint sub board is integrated in the LCD back cover assy (LCD back cover for
SIM W / FP) and must be completely replaced if defective. The fingerprint sub board is not available separately.
Return to Table of Contents
Service Partner only

Related product manuals