Fujitsu UTY-DCGYZ3 - Page 20

En-20
2-2-2-2. TemperatureUpperandLowerLimitSetting
Set the temperature upper and lower limit setting of “Auto”, “Cool/Dry”, and “Heat”.
 4 6

3 5 7
No. Item Description

Set temperature “Enable” / “Disable”
Sets “Enable” or “Disable” of upper and lower limit setting. Select from
“Enable” or “Disable”.

“Auto” upper limit
Sets the “Auto” upper limit with 0.5ºC (1ºF) increments.
Range: 18.0 to 30.0ºC (64 to 88ºF)
3
“Auto” lower limit
Sets the “Auto” lower limit with 0.5ºC (1ºF) increments.
Range: 18.0 to 30.0ºC (64 to 88ºF)
4
“Cool/Dry” upper limit
Sets the “Cool/Dry” upper limit with 0.5ºC (1ºF) increments.
Range: 18.0 to 32.0ºC (64 to 91ºF)
5
“Cool/Dry” lower limit
Sets the “Cool/Dry” lower limit with 0.5ºC (1ºF) increments.
Range: 18.0 to 32.0ºC (64 to 91ºF)
6
“Heat” upper limit
Sets the “Heat” upper limit with 0.5ºC (1ºF) increments.
Range: 10.0 to 30.0ºC (48 to 88ºF)
7
“Heat” lower limit
Sets the “Heat” lower limit with 0.5ºC (1ºF) increments.
Range: 10.0 to 30.0ºC (48 to 88ºF)
* Thetemperatureupperandlowerlimitthatcanbesetmaydi󰀨erdependingontheregisteredindoorunit.
2-2-2-3. RemoteControllerProhibitionSetting
Set the prohibited operations of remote controller.

No. Item Description

Selected status
Switches between enabled and disabled state by checking the checkbox.
(When checked, the setting is prohibited.)
“All”,“On/O󰀨”,“On”,“Mode”,“Temp”,“Timer”,and“FilterReset”canbeset
to prohibited state.
When “All” is checked, other checkboxes are disabled.