Fujitsu UTY-DCGYZ3 - Indoor Unit Registration

En-42
3-5-3. IndoorUnitRegistration
Register the indoor unit to be controlled by this controller.
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Indoor Unit Registration].
(4) Select the process from the submenu below.
No. Item Description

“Address
Number
Registration”
Deletes the currently registered indoor
units and registers the indoor units in
ascending order of address.
→Refer to 3-5-3-1.

“Manual
Registration”
Registers the indoor units manually
without deleting the currently registered
indoorunits.→Refer to 3-5-3-2.
When “Address Number Registration” is performed, the
registered address setting will be deleted. In the case of
manual registration, the registered address is not deleted.
Note
3-5-3-1. AddressNumberRegistration
Registertheindoorunitsinthespeciedrefrigerantsystemrange.
(1) Set the item and tap the [Register] button.
No. Item Description

“Refrigerant
System Range”
Inputs “Refrigerant System Range” to
be registered for indoor unit.
[Initial value: - ] Maximum 3 ranges
can be set.

“Setting of
Network
Priority Mode”
Selects from “Priority Mode” or
“Normal”.
“Priority Mode”: Performs the scan by
stopping the system.
3
Registration
method
Selects from “New” or “Add”.
“New”: Deletes the registered indoor
unit to register newly.
“Add”: Adds to the registered indoor
unit to register.
4
(Checkbox)
“Create a
new group
automatically.”
• When the checkbox is checked, the
group of only the newly added indoor
unit (R.C.G.) is created. When not
checked, the newly added indoor unit
does not belong to the group.
• Created group name: Group **
* When some users operate remotely, the left message is
displayed. When the [OK] button is tapped, all connections
will be disconnected by this operation.
(2) Registertheindoorunit.→Refer to 3-5-3-3.
(2)
(3)
(1)



3
4
