Fujitsu UTY-DCGYZ3 - Page 49

En-49
(When “Operation Stop Time” is selected) (When “Start Time” and “End Time” are selected)
3-5-9-2. Set Temp. Auto Return
Set the item and tap the [OK] button.
No. Item Description

“Set Temp. Auto
Return”
Sets “Enable” or “Disable” of the timer.
When “Enable” is selected,  to 3
are enabled.

“Return Time
(Cool / Dry)”
Sets “Return Time (Cool / Dry)” in
10-minutes unit. [10-240 min]
3
“Retur n Temp.
(Cool / Dry)”
Sets “Return Temp. (Cool / Dry)” in
0.5°C / 1°F unit.
The temperature range to be displayed
is based on the Temperature Upper
andLowerLimitSetting.→Refer to
2-2-2-2.
4
“Return Time
(Heat)”
Sets “Return Time (Heat)” in
10-minutes unit. [10-240 min]
5
“Retur n Temp.
(Heat)”
Sets “Return Temp.(Heat)” in 0.5°C /
1°F unit.
The temperature range to be displayed
is based on the Temperature Upper
andLowerLimitSetting.→Refer to
2-2-2-2.
6
“Registered
Groups”
Sets the groups to be controlled.
→Refer to 2-3-1-1.
(When “Return Time” is selected) (When “Return Temp.” is selected)


4
5
3
6