Fujitsu Waterstage Split Comfort 5 Series - Page 41

- 41 -
Ref. Functions - Defi nition of the functions
1 Selecting the DHW operation
Marche
Arrêt
- Start: Production of DHW in function of the timer programme.
- Stop: Production of the DHW stopped with antifreeze function of the
domestic water active.
- Manual start button: Press the DHW button for 3 s
(switches from "reduced" to "comfort" until the DHW timer programme is
switched again).
2 Digital display - Check the operation, read the current temperature of the heating operation,
or a possible fault.
- View the settings.
3 "ESC" output - Exit the menu.
4 Navigation and setting - Setting the comfort temperature value.
- Menu selection
- Setting the parameters.
5 Selecting the heating operation
-
Auto
Service heating according to the heating programme
(automatic summer/winter switching).
-
Permanent comfort temperature.
-
Permanent reduced temperature.
-
"Stand-by" operation with antifreeze protection
(provided that the electrical power supply of the heat pump is not interrupted).
6 Displaying information - Miscellaneous information (see
"Information display", page 64).
-
Reading the error codes (see page 66).
-
Information on maintenance, special operation.
7 Validation "OK" - Enter the selected menu.
- Validate the parameter settings.
- Validate the comfort temperature value setting.
8 Selection of the Cooling mode*
-
Service cooling according to the heating programme
(automatic summer/winter switching).
9 Reset
(Press and relief)
- Reset the parameters and cancel the error messages.
Do not use during normal operation
10 Setting button - Setting the comfort temperature value.
11 Presence button - Comfort / reduced switching.
* according option
ON
OFF
Waterstage Split Comfort DHW Serie / INSTALLATION / 2125 - EN