Fujitsu WOxK112LCT - Automatic Storage

- (CS01 - 21) -
Control system
- (CS01 - 21) -
CONTROL SYSTEM CONTROL SYSTEM
Operator section functions
z
LINE FUNCTION
20 Language
22 Info
26 Operation lock
27 Programming lock
28 Direct adjustment
29 Temperature unit
Pressure unit
Info
Temporarily •
After pressing the Info key, the information display
returns "predened" basic display after 8
minutes or when pressing the operating mode key.
Permanently •
After pressing the Info key, the information display
returns to "new" basic display after a maximum of
8 minutes. The last selected information value is
shown in the new basic display.
Operation lock
If the operating lock is activated, the following
control elements can no longer be adjusted:
Heating circuit mode, DHW mode, room temp
comfort setpoint (knob), occupancy key.
Programming lock
If the programming lock is activated, the setting
values are displayed but may no longer be
changed.
Temporary suspension of programming:
The programming lock can be temporarily
deactivated at programming level. To do this,
simultaneously press OK and ESC keys for at
least 3 seconds. The temporary suspension of the
programming lock remains in effect until you exit
the programming.
Permanent suspension of programming:
First perform a temporary suspension, then cancel
"Programming lock" on line 27.
Direct adjustment
Storage with conrmation •
Correction of the setpoint with the knob will be
adopted only after pressing OK key.
Automatic storage •
Correction of the setpoint with the knob is adopted
without a particular conrmation (timeout) or by
pressing OK key.
Heating Circuit Assignment
LINE FUNCTION
70 Software version (user interface)
applies only to Remote control C75

*
Software version (user interface)
The display shows the current version of the user
interface.