Fujitsu XG0224 - Ether Recovery Limit

XG Series User's Guide Chapter 5 Command Reference
Port Information Settings
106
5.1.1.15 ether recovery limit
Function Set the upper limit number of linkdown times.
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax ether <number> recovery limit <limit>
Options
<number>
•
ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<limit>
•
Number of linkdown times
Set the upper limit number of linkdown times, for the ports to go offline, with a decimal
value from 1 to 10.
Use Mode Configuration mode (admin class)
Explanation Set the number of times for linkdown as the upper limit for the relevant ports to go offline.
When the upper limit has been exceeded, the log is output to the SYSLOG and the ports
are offline.
Caution
•
If ports are offline, release them with the "online" command with port releasing.
• When offline ports are released by with "online" command, the number of times for
linkdown is reset to zero again.
Default The ports are not offline during linkdown, assuming that there is no upper limit.