XG Series User's Guide Chapter 5 Command Reference
Port Information Settings
124
<broadcast>
<multicast>
Set the operation that occurs if the traffic exceeds the threshold.
• off
The guard function is disabled.
• discard
Discard the packets that exceed the threshold.
• close
Close the port (offline).
Use Mode Configuration mode (admin class)
Explanation
XG0224 / XG0448 / XG0440DC / XG0440DCR
Set the broadcast or multicast storm control information.
If "discard" or "close" is specified, the systemlog is output when the threshold value is
exceeded or the device is restored.
XG2600
Set the broadcast or multicast storm control information.
If "discard" or "close" is specified, the systemlog is output when the threshold value is
exceeded or the device is restored.
Storm monitoring doesn’t start If the threshold of both broadcast and multicast is set to 0.
Caution
XG0224 / XG0448 / XG0440DC / XG0440DCR
It might be considered that broadcast/multicast roughhouse control information is set,
and "clear statistics" is restored from the state of the roughhouse once when it retreats
and the statistical information of correspondence port is cleared with the reception rate
exceeds the threshold.
Default N/A
To Next Page
Loading...
