Fujitsu XG0224 - Ether Stp Domain Priority

XG Series User's Guide Chapter 5 Command Reference
Port Information Settings
127
5.1.3.3 ether stp domain priority
Function Set the priority.
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax ether <number> stp domain <instance-id> priority <priority>
Options
<number>
•
ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<instance-id>
•
Instance ID number
Specify a decimal value from 0 to 15.
For non-MSTP operation mode, entering a value from 1 to 15 makes it invalid, although
the allowable range is set with a value from 0 to 15.
<priority>
•
Priority
Set the port priority with a decimal value from 0 to 240.
A smaller value has a higher priority.
Use Mode Configuration mode (admin class)
Explanation Set the port priority.
Caution Specify an integer (valid value) that can be divided by 16 in <priority>.
Valid values: 0, 16, 32, 48, 64, 80, 96, 112, 128, 144, 160, 176, 192, 208, 224, 240
If an integer other than the valid values is specified, this setting is disabled.
The priority specified by the instance ID 1 to 15 is valid only when the device is in the
MSTP operation mode (stp mode mstp), but the set value is ignored when the device is in
the non-MSTP operation mode.
Default It is assumed that 128 is used for the STP port priority.
ether <number> stp domain 0 priority 128