XG Series User's Guide Chapter 5 Command Reference
VLAN Information Settings
164
5.3.2.3 vlan igmpsnoop source
Function Set the IP address to be used for IGMP snooping.
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax vlan <vid> igmpsnoop source <address>
Options
<vid>
•
VLAN ID
Specify a VLAN ID with a decimal value.
<address>
Specify the source IP address to be used for IGMP snooping.
This IP address is used as the source address for all IGMP packets.
Use Mode Configuration mode (admin class)
Explanation Specify the source address of IGMP packets sent by IGMP snooping.
Caution
•
This setting is enabled only when IGMP snooping is set to use.
This setting is ignored if IGMP snooping is not used.
• When IGMP snooping is used, set the Querier IP address.
• To make the querier operation enabled, set an address whose value is greater than the
multicast router address.
• When connecting multiple IGMP snooping devices, do not set the addresses of two or
more devices within the same VLAN.
Default IGMP packets are sent with the source address 0.0.0.0.
vlan <vid> igmpsnoop source 0.0.0.0
To Next Page
Loading...
