XG Series User's Guide Chapter 5 Command Reference
Device Information Settings
328
5.15.8.38 serverinfo sntp filter move
Function Change the priority of the application filter for the SNTP server function.
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax serverinfo sntp filter move <count> <new_count>
Options
<count>
•
Target filtering definition number
Specify a filtering definition number of which the priority is to be changed.
<new_count>
•
Destination filtering definition number
Specify a new priority for <count> with a decimal value from 0 to 29.
If any definition with the same definition number exists, it will be inserted before the
existing one.
Use Mode Configuration mode (admin class)
Explanation Change the priority of the application filter for the SNTP server function.
5.15.8.39 serverinfo sntp filter default
Function Set the default operation of the application filter for the SNTP server function.
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax serverinfo sntp filter default <action>
Options
<action>
Specify how to handle a packet that did not match any application filter table for the SNTP
server function.
• accept
Transmit the relevant packet.
• reject
Block the relevant packet.
Use Mode Configuration mode (admin class)
Explanation Set how to handle a packet that did not match any application filter table for the SNTP
server function.
Default A packet that did not match any application filter table is transmitted.
serverinfo sntp filter default accept
To Next Page
Loading...
