Fujitsu XG0224 - Show Usb Storage Status

XG Series User's Guide Chapter 5 Command Reference
USB connection Counter, Log, Statistics, and Status Display and Clear
Operation Commands
432
5.21.1.2 show usb storage status
Function Displays USB mass storage controller status.
Available Model XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax show usb storage status
Options N/A
Use Mode Operation mode (user class /admin class/CE class)
Configuration mode (admin class/CE class)
Explanation Displays current status for USB mass storage controller.
Default
1) USB mass storage controller thread status
Status is displayed via the following messages:
Uninit: not initialized
Waiting for USBD active
Waiting for entry class completed
Active
The information below is displayed only when a connected USB device has
been detected.
# show usb storage status
[Thread]
Status : Active ---(1)
[Device #1]
Status : Idle ---(2)
Speed : Full ---(3)
Geometry probing : Success ---(4)
Test unit ready : Success ---(5)
Inquiry : Success
Mode sense : Success
Read capacity : Success
Read format capacities : ----
Hold data : Not exist ---(6)
Error status : Get device specs [5/5] (Read format capacities) ---(7)
Error reason : Transfer URB failure ---(8)
Error event : 0x3200000d ---(9)
Request sense code : (02, 10, 00) ---(10)
[Storage specs]
Vendor : FUJITSU ---(11)
Product : USB PortableDrive ---(12)
Product Rev. : 3.96 ---(13)
Total sectors : 500400 ---(14)
Cylinders : 695 ---(15)
Heads : 15 ---(16)
Sectors per track : 48 ---(17)
[USB specs]
Speed : Full ---(18)
Max LUN : 3 ---(19)
[USB configuration]
Device address : 1 ---(20)
Interface : 0 ---(21)
Sub class : 6 ---(22)
LUN : 0 ---(23)
BulkInEP : 0x82 ---(24)
BulkOutEP : 0x02 ---(25)