XG Series User's Guide Chapter 5 Command Reference
Routing Table Entry Display Commands
456
1) Destination/Masklen
The destination network address and the mask value are displayed.
If routed via the host, no mask value is displayed.
Gateway: The gateway address is displayed.
The direct route indicates the MAC address of the gateway. If the
gateway address is not resolved, link#x is shown (where, x is an
interface index number that the system automatically assigns to each
interface).
Flag : The entry type is displayed. The details are as follows.
U (Up) : Indicates that the route is enabled.
G (Gateway) : Indicates the route which requires an
intermediaterouting such as gateway.
H (Host) : Indicates the host entry.
S (Static) : Indicates the static route.
R (Reject) : Indicates the discarded route (with ICMP unreach
transmission).
B (Blackhole) : Indicates the discarded route (without ICMP unreach
transmission).
Interface: The destination interface is shown.
2) Entry
The number of entries, excluding the route entries used inside the device, is
displayed.
To Next Page
Loading...
