Fujitsu XG0224 - Show Igmpsnoop Reporter

XG Series User's Guide Chapter 5 Command Reference
IGMP Snooping Counter, Log, Statistics, and Status Display and Clear
Operation Commands
517
5.33.1.3 show igmpsnoop reporter
Function Display the multicast listener information.
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax show igmpsnoop reporter [<vidlist>]
Options
N/A
Display information about all VLANs with the valid IGMP snooping.
<vidlist>
Specify a VID of VLAN to display the IGMP snooping information.
When specifying multiple VLANs, separate them with commas (,).
Also, when specifying the range, specify them with hyphens (-). (Example: 1-3)
The available description format is as follows:
• To specify values 1, 2, 3, 5 and 7 in the "vidlist"
Example: 1-3, 5, 7
• To specify values 1, 3 and 5 in the "vidlist"
Example: 1, 3, 5
Use Mode Operation mode (user class/admin class)
Configuration mode (admin class)
Explanation Display the multicast listener information being held by IGMP snooping.
Execution Example
1) The number of source address information
2) The number of registered listener information
3) Source address and multicast group address
4) Port number
A hyphen (-) shows a group where no listener exists.
5) IP address to which the Membership-Report has been sent
A hyphen (-) shows a group where no listener exists.
6) The elapsed time after participation in the multicast group
If no listener exists, a hyphen (-) is shown.
# show igmpsnoop reporter 1-3
IGMP Snooping statistics: VLAN 1
#sources: 0 (1)
#hosts: 4 (2)
Source/Group Port Reporter Join
------------------------------- ---- --------------- --------
(3) (4) (5) (6)
0.0.0.0 /239.1.1.1 1 10.5.20.18 1:10:00
2 10.5.20.31 1:10:02
0.0.0.0 /239.1.1.2 3 10.5.20.22 1:10:03
0.0.0.0 /239.1.1.3 3 10.5.20.25 1:10:03
0.0.0.0 /239.1.1.10 - - -