XG Series User's Guide Chapter 6 Managing the Device
Saving/Restoring Configuration Information
584
Restoring configuration information using a CompactFlash card
The following explains how to restore device configuration information that has been saved to a CompactFlash card.
1. Insert the CompactFlash card containing the configuration information into the device’s
CompactFlash card slot.
2. Restore configuration information from the CompactFlash card.
z Example
The following example restores configuration information 2 from the config2-1 file.
6.2.3 Saving/restoring configuration information using USB
memory
You can save the device’s configuration information on USB memory. If necessary, you can also restore the configuration
information saved on USB memory.
z Configuration information which can be saved
• Candidate configuration : candidate-config
• Running configuration : running-config
• Configuration information 1 : config1
• Configuration information 2 : config2
The following explains how to save/restore configuration information using USB memory.
Saving configuration information using USB memory
The following explains how to save the configuration information of this device to USB memory.
1. Insert USB memory on which you will save the configuration information into the USB port of the
device.
2. Release the block status of the USB port.
3. Confirm that the block status of the USB port has been released.
Run a show usb hcd status command and ensure that the status displays "enable".
# copy /cf0/config2-1 config2
# reset : Restart the device.
Note
Be sure to restart the device to so that the restored configuration information can take effect.
AvailableModel
XG0448 / XG0440DC / XG0440DCR / XG2600
# usbctl enable
# show usb hcd status
[USB HCD STATUS]
status : enable
To Next Page
Loading...
