●
●●
●
Checks and maintenance before and after off-road use
In order to avoid problems connected to the operation of the vehicle, it is advisable to perform
a number of checks and maintenance operations before and after use. Just a few minutes
given to these procedures will save you time and money, and will make riding much safer.
Proceed as follows:
· Check pressure, general condition and thickness of tread.
· On cold days, warm up the engine by running it at idle speed for a few minutes before
starting off.
· Wash the vehicle carefully after every off-road use.
●
●●
●
Fueling operations
Remove cap A counterclockwise.
The fuel tank will hold approximately 1.5 liter.
Only use green fuel mixture with 4% oil.
●
●●
●
Breaking in
During the first 25 hours of operation running-in), the following precautions should be used;
- Avoid travel at high speeds
- Change speed often so that the parts will break in uniformly and in a shorter time
- Avoid turning the throttle more that 3/4 of the way.
Warning:
·Change the crankcase oil after 500km.
·Always use a mixture of green grade gas and a qualitatively good oil.
·After the first off-road use, check all of the nuts and bolts.
●
●●
● Startup
Manual hand pull
-Open fuel tank valve A ON = open
- Sharply pull on the starter as shown in the figure
while slightly turning the throttle twist grip.
-Always close the fuel tank valve when the engine is off.
Note:
With the engine is cold, act on the starter by pushing down
lever B, wait for a short and then reposition the lever to its
former position.
To Next Page
Loading...