S179A Quick Reference Guide
FTS-B526
① Turn on power.
< Fiber Preparation >
tissue with
ethanol
Place fiber on Single
Fiber Adapter.
Hold the fiber tightly.
Then move stripper into
the direction indicated
by the arrow mark.
Safety Instructions
Before operating this device, please consult the user manual for safety
instructions. These guidelines will enable you to operate the product in a
safe and correct manner in order to prevent harm to yourself and others.
Splicing Procedure
End.
⑫ Remove the fiber.
⑪
Press
key or icon.
⑩ Transfer fiber to heater.
⑨ Slide protection sleeve over
splice point.
⑧ Remove spliced fiber.
⑦
Press key or icon.
⑥ Set fibers in splicer.
⑤ Prepare the fibers.
④ Insert protection sleeve.
③ Perform Arc Check.
※ Please see “Arc Check” for
② Select applicable program.
The edge of the fiber coating should
match with the edge of the tight holder.
Press lever.
To Next Page
Need help?
General
