4.4 Synchronous Belt and Motor
17
4.4 Synchronous Belt and Motor
To remove the belt and motor:
1. Unscrew four M3x8 screws marked by *.
2. Remove the radiator assembly.
3. Replace the belt (or motor) with new one. No belt tension adjustment is necessary.
4. Reassemble the unit by reversing above steps.
Fig.4-7
M3 X 6 SCM3
M3 X 8 2pcs.
Driving Pulley
STS Belt
B801 Motor
Connector
Fix at the
same time.
Radiator Assy.
Connector
* M3 X 8 4pcs.
Driver Pulley
Bearing
Retainer
Two dowels
Use this hole to loosen
the screw fixing the
nearing retainer.
dowels
Driver pulley, top view
View from B
Belt
Driving pulley Driver pulley
03-146-3304
RM-9572
(000-808-743)
B
To Next Page
Loading...
