Furuno 1932 MARK-2 - Compliance Information; Compliance with R&TTE Directive

iii
TABLE OF CONTENTS
SYSTEM CONFIGURATION ............................................................. iv
EQUIPMENTS LIST ............................................................................v
1. MOUNTING
1.1 Mounting Methods for Scanner Unit..................................................................1-1
1.2 Fixing Holes in Mounting Platform ....................................................................1-1
1.3 Fastning the Radiator to the Radiator Bracket ..................................................1-2
1.4 Mounting the Scanner Unit................................................................................1-2
1.5 Display Unit Mounting .......................................................................................1-4
2. CONNECTIONS
2.1 Connecting the Signal Cable.............................................................................2-1
2.2 Display Unit Connections ..................................................................................2-2
2.3 Connection of External Equipment....................................................................2-3
2.4 Exchange of Fuse for 24/32V Power Supply.....................................................2-4
2.5 Checking the Installation ...................................................................................2-4
3. ADJUSTMENTS
3.1 Preparation........................................................................................................3-1
3.2 Adjusting Tuning/Video......................................................................................3-1
3.3 Entering Antenna Height ...................................................................................3-1
3.4 Aligning Heading ...............................................................................................3-2
3.5 Adjusting Sweep Timing ....................................................................................3-2
3.6 Adjusting MBS ...................................................................................................3-3
3.7 Selecting STC Curve.........................................................................................3-3
3.8 Setting Dead Sector ..........................................................................................3-3
3.9 Checking Magnetron Heater Voltage ................................................................3-4
4. INSTALLATION OF ARP-10 (OPTION)
4.1 Necessary Parts ................................................................................................4-1
4.2 Mounting ...........................................................................................................4-1
4.3 Adjustments.......................................................................................................4-1
INSTALLATION MATERIALS, ACCESORIES, SPARE PARTS..... A-1
OUTLINE DRAWING ...................................................................... D-1
SCHEMATIC DIAGRAM ................................................................. S-1