Furuno DS-60 - Page 15

1. INSTALLATION
1-9
5) Attach the metal fixing (supplied) to the connector, and use two bolts M6x20
and spring washers M6 to fix them.
11. Pass the fixing gland (6), washer (7) and gasket (8) through the transducer cable
(DS-631: cable assy), and slide them to the white line on the cable.
12. Pass the cable through the hole at the top of the tank (2).
Metal fixing
Hex. bolt (M6x20)
Spring washer
(M6)
Cable assy.
White line
(printed on the cable)
Fixing gland (6)
Washer (7)
(The hollow side must be upward.)
Gasket (8)
Tank (2)
Transducer cable