Furuno DS-60 - Page 44

3. MENU SETTINGS
3-4
3.2.2 How to set ship’s data
Enter the dimensions of your ship’s on the [Setting Ships Data] menu.
1. Press  to select [Setting Ship’s Data], and press the ENT key to show the Set-
ting Ships Data menu.
[Setting Ship’s Data] menu
2. Select an item, and press the ENT key to show the setting window.
Refer to the table in below to enter the dimensions.
3. Press the MENU/ESC key to close the menu.
Item Meaning Setting range
[LOA] Ship’s length 50.0 to 400.0 m
[B] Ship’s width 5.0 to 100.0 m
[L1] Horizontal distance from the ship’s bow to
transducer
0.0 m to the setting value for [LOA]
[L2] Horizontal distance from port to transducer 0.0 m to the setting value for [B]
[L3] Horizontal distance from ship’s bow to
GPS antenna
0.0 m to the setting value for [LOA]
[L4] Horizontal distance from port to GPS an-
tenna
0.0 m to setting value for [B]
[L5] Horizontal distance from ship’s bow and
CCRP (bridge)
0.0 m to setting value for [LOA]
[D] Horizontal distance between transducers
for DS-60 and echo sounder.
0.0 m to ([LOA]-[L1])