29
7. Select DATA OUTPUT and press the [ENT] key.
8. Press # to select ON and press the [ENT] key.
9. Press the [DISP] key.
10. Confirm the value displayed is the same as it entered at step 5.
Confirm the same as speed is shown on external equipment (radar, GPS, etc.).
11. Select OFF at DATA OUTPUT, and press the [ENTER] key.
3.4 Setting of Maximum Speed Range
Change the maximum range of the connected analog display by setting ofDIP switch S2 in the
distribution box.
Maximum speed 20 kt 30 kt 40 kt
S2 #1: ON
Others: OFF
All: OFF #2: ON
Others: OFF
JPW Board
(65P6010)
Distribution box DS-801,
inside view
S2
(Default setting: all OFF)
Distribution box, cover removed
3.5 Ship's Speed Adjustments
Adjusts the speed error using the test sheet on page AP-3 recorded.
1. Press the [MENU] key.
2. Select SYSTEM MENU, and press the [ENT] key.
3. Select SPEED OFFSET, and press the [ENT] key.
4. Use the cursor pad to enter the digit.
5. Press the [ENT] key.
6. Press the [MENU] key.
For detail, see page AP-1.
To Next Page
Loading...
