Furuno FAR-2018-MARK-2 - 1.48 Interswitch; 1.48.1 How to display antenna information

1. OPERATIONAL OVERVIEW
1-91
1.48 Interswitch
The interswitch of this radar uses an Ethernet to transfer video and control signals. A
digital signal transfers the video and control signals. You can connect up to four an-
tennas and four display units. Set radar display and antenna groups from the [ANTEN-
NA SELECT] display.
When you switch to a different antenna, the heading skew and timing adjustment (set
at installation) for that antenna are automatically applied.
The [ANTENNA] box at the upper left position shows current antenna selection.
1.48.1 How to display antenna information
1. Open the menu.
2. Select [9 INITIAL SETTINGS].
3. Select [3 SELECT ANTENNA]. The [SELECT ANTENNA] menu appears.
Note: You can also right-click the [ANTENNA] box to access this menu.
Note: For configurations with processors assigned as [DISP5]/[DISP6]/[DISP7]/
[DISP8] at installation, the processor unit automatically connects to the system as
[SLAVE] when first turned on. You can change this setting after the first connection.
See section 1.48.2.
Antenna box
ANTx: “x” indicates antenna selected.
(M) or (S): indicates antenna is (M)aster or (S)lave.
X-Band or S-Band: indicates antenna bandwidth.
The following information is displayed in the [SELECT ANTENNA] menu:
• Radar band, output power and antenna position of each antenna
currently powered. (If an antenna is not powered, its data area is blank.)
• Own ship radar number (radar in use).
• Current antenna and display combinations.
SELECT ANTENNA
1 BACK
ANT 1 : X-BAND
25UP Main Top
ANT 2 : S-BAND
30UP Main 2nd
ANT 3 : X-BAND
12 Fore
ANT 4 : X-BAND
12 Aft
OWN RADAR NO.1
2 DISP1 ANT1
MASTER
DISP2 ANT2
MASTER
DISP3 ANT3
MASTER
DISP4 ANT4
MASTER
9 SAVE INTER-SWITCH
NO / YES
0 CLEAR INTER-SWITCH
NO / YES
←
←
Using the information displayed in this example the antenna system configuration would
look something like this.
ANT1
ANT2
ANT3
ANT4
Antenna Unit
Processor Unit
HUB-3000
DISP1 DISP2
DISP3 DISP4