1. OPERATIONAL OVERVIEW
1-64
1.37.5 Narrow trails (B/W-type only)
Target trails can be painted with thinner lines if desired. This csection 1.37.2an be
useful when there are a lot of targets on the screen and it is hard to distinguish one
from another.
1. Open the menu.
2. Select [1 ECHO].
3. Select [0 NEXT].
4. Select [4 TRAILS]. The [TRAILS] menu appears.
Note: You can also right-click the [TRAIL] box to access this menu.
5. Select [8 NARROW TRAIL].
6. Select the appropriate setting from [OFF], [1] or [2], then press the ENTER MARK
key. A trail with a setting of [2] is thinner than a trail with a setting of [1].
7. Close the menu.
1.37.6 How to hide the trails temporarily
Following the procedure outlined in section 1.37.2, set the trail time to [OFF]. The trails
are hidden from view, but are continued. To show the trails again, repeat the proce-
dure, setting the trail time to any interval other than [OFF].
1.37.7 Trail stabilization in true motion
True motion trails can be ground stabilized or sea stabilized. The [TRAIL] box shows
current stabilization as "TRUE-G" or "TRUE-S". You can change the stabilization
mode with the following procedure.
Note: The stabilization mode is applied to own ship speed and TT trails.
Using the on-screen box
Click the stabilization mode button to toggle the mode (BT
(ground stabilization) or WT (see stabilization)).
Using the menu
1. Open the menu.
2. Select [7 INFORMATION BOX].
3. Select [2 OWN SHIP INFO].
4. Select [3 SPEED]. The [SPEED] menu appears.
Note: You can also right-click the [SPD ] indication to access this menu.
5. Select [2 SHIP SPEED].
6. Select [LOG(BT)] (ground stabilization) or [LOG(WT)] (sea stabilization) as re-
quired.
7. Close the menu.
Stabilization mode button
To Next Page
Loading...
