Furuno FAR-2107 Series - Page 17

15
30 Connect the cable between the BNC connector converter and the DVI-RGB conversion kit
as shown below.
31 Fasten the front cover to the console.
1) Set the front cover to two receptacles for cover.
2) Fasten the front cover to the console with two screws (M6×25).
12
3
4
5
6
DSUB-BNC-1
PSU-007
c)-1. Coil cable twice
and clamp it.
c)-2. Additionaly, coil it
three times and
bind it with cable tie.
Cable Tie
CV-200N
DSUB Connector Cable
from Processor Unit
1.3 - 1.4 m1.3 - 1.4 m
a)
b)
b)
c)
d)
Procedure
a) Fasten connector to BNC connector
converter.
b) Clamp cable at two place (attend to size
of figure).
c) Coil surplus cable. Clamp and
bind it.
d) Bind surplus cable (1.3 - 1.4 m,
for pulling out the processor
unit).