Furuno FAR-2107 Series - Page 7

5
4 Fasten the Memory Card Interface Unit CU-200 (option) to the console (see the accessories
at page A-12).
1) From the bottom cover of the console panel, remove round cap and replace it with grommet (supplied).
2) Set the CU-200 to the mounting bracket (19-023-3091) and fasten it with four washerhead screws
(M4×10).
3) Connect power cable, ground wire and LAN cable to the CU-200. Route those cables through the grom-
met and draw them into the console.
4) Fasten the CU-200 assembly to the bottom cover of the console panel with four each of spring washers
(M4), flat washers (M4) and nuts (M4). See the figure below.
5) Refasten the bottom cover of the console with ten screws (M4×15).
6) Route the power cable through the right duct.
5 Fasten the Switching Hub (option) to the console (see page A-13 and A-14).
1) Remove the top cover of the console by unfastening six screws (M4×8).
2) Fasten the hub mounting plate (03-163-7225) to the console with six washer-head screws (M4×10).
3) Set the right and left mounting legs of the Switching Hub to the bottom stoppers of the mounting plate.
4) Attach the hub fixing rubber to the hub fixing plate (03-163-7226). Fasten the top of the Switching Hub
with two washer-head screws (M4×15) and hub fixing plate.
5) Connect power cable (NR203PF-VVS1.25 0.3M), ground wire and LAN cable (P5E-4PTX-BL L=2M) to
the Switching Hub.
Grommet
Mounting Bracket
(Set the CU-200)
Bottom Cover of
Console Panel
View
A
Ground Wire
A
B
B
Switching Hub
HUB-100
Power Cable
(NR203PF-VVS1.25 0.3M)
Hub Mounting Plate
Washerhead Screw
(M4x10, 6 pcs.)
3 pcs. at either side
Terminal Board TB4
Hub Fixing Plate
Washerhead Screw
(M4x15, 2 pcs.)
LAN Port of Switching Hub
View