Furuno FAR-2127 - Location of Parts

4.7 Setting of AD-100 or GC-10
4-47
4.7.2 Location of Parts
Fig. 4.7.2 Location of 64P1106-99 Board
JP4
JP5
JP2 JP3
JP1
J7-12:
Data output port
J7, 8, 9 -> 25 ms
J10, 11, 12 -> 200 ms
J6:
NMEA output port
J4: Stator signal input
JP6, 7:
AD output interval
(25 ms/200 ms)
CR21: CPU RUN
(OK when the LED blinks)
JP4, 5: Operating voltage setting
SW3:
Baud rate
Version
Ver03, 04: Talker name
Ver05: Power-off function
SW1:
- Ratio
- Gyro type
- Frequency setting
SW2:
- Rotor voltage
- Stator voltage
- Self test
- NMEA output interval
etc.
J5: Rotor signal input
J1: Gyro type setting
JP6 JP7
SW2
SW
１
１１
１
SW3
JP2: Stator voltage setting
JP3: Rotor voltage setting