Furuno FAR-2218-BB - How to Change PI Line Length

1. OPERATIONAL OVERVIEW
1-69
1.40.6 How to change PI line length
You can change the length of the PI lines. This function is only available when [SET
MAXIMUM PI LINES] is set to [1]. If not already displayed, you can show PI lines for
which you wish to change the length by referring to section 1.40.1.
1. Open the menu.
2. Select [3 NAV TOOLS].
3. Select [2 PI LINES].
4. Select [6 TRUNC RANGE 1].
5. Select [ON], then press the ENTER MARK key.
6. Spin the scrollwheel to adjust the front PI line length. The available range is 0.000
NM to 24.000 NM. All PI lines beyond this mark will be hidden.
7. Left-click to confirm the setting.
8. Select [7 TRUNC RANGE 2].
9. Select [ON], then press the ENTER MARK key.
10. Spin the scrollwheel to adjust the front PI line length. The available range is 0.000
NM to 24.000 NM. All PI lines beyond this mark will be hidden.
11. To change the length of other PI lines, activate the line you wish to adjust, then
repeat steps 1 through 10.
12. Close the menu.
Heading line PI line
TRUNC RANGE 1 length settingTRUNC RANGE 1 length setting
TRUNC RANGE 2 length settingTRUNC RANGE 2 length setting
OS location