3. ADJUSTMENTS
3-25
[EAV W/O GYRO]
The echo averaging feature can be used without a gyrocompass. Select [ON] to use
the feature without a gyrocompass (default: [OFF]).
[ECDIS]
Select the ECDIS communication method, [SERIAL] or [LAN]. Select [OFF] for no EC-
DIS connection (default: [OFF]).
[EXT BRILL CONTROL]
Select [ON] to adjust the brilliance of the monitor unit from external equipment.
[SSD SUB OUTPUT]
Note: Not used with magnetron radars.
For solid state radars (FAR-2238S-NXT(-BB)/FAR-2338S-NXT), if the digital signal
can be output in analog format to a sub monitor, select [ON].
[OVERLAY1 (2)]
Note: This menu is NOT available for C-type radars.
When an ECDIS is connected, the radar picture can be
overlaid on the ECDIS. Set the items on this menu to
correctly overlay the radar picture on ECDIS.
Note: The overlay output is less accurate than the sub
monitor output from the Antenna Unit, especially in the
areas mentioned below. Therefore, only use the overlay
with an ECDIS.
• Distance accuracy/resolution
• Bearing accuracy/resolution
• Sweep
• Echo picture
• Range
When the echo image is NOT used with ECDIS, use the signal from the Antenna Unit.
[RP UPDATE]
For C-type and A/B/W radars with Radar Plotter
functionality, conduct updates for the RP board (CC6).
• [APPLICATION]: Update the RP board (CC6) soft-
ware.
• [OS]: Update the RP board (CC6) OS (operating sys-
tem).
• [CHART SYMBOL]: Update the RP board (CC6) chart symbols.
• [REMOVE USB MEMORY]: Remove a USB flash memory from the RP board
(CC6).
RP UPDATE
APPLICATION
OS
CHART SYMBOL
REMOVE USB MEMORY
To Next Page
Loading...
