2. WIRING
2-53
3. Connect the cable for Control Unit to the connectors (TB711 and TB712) through
the appropriate wiring clamps (A) and (B).
Connection of cable for sub monitor
Up to four cables (RW-00136, RW-
4864) can be uses as sub monitor ca-
bles. Set their cables on the specified
cable entrance as shown in the figure
to the right.
1. Set the shield part of the sub monitor cables on the appropriate lanes on the up-
per/lower cable entrances as shown below. Fasten the shield part of the cable
with the cable clamp.
2. Connect the sub monitor cables to the connectors. The cable for input signal of an
external radar should be connected to the connector J710.
• RW-4864 on the upper entrances: max. two lines through the wiring clamps (A)
and (B) to two of connectors J708, J709, J710 or J717. See the dashed lines in
the figure below.
• RW-4864 on the lower entrances: max. two lines through the wiring clamps (B)
to (E) to two of connectors J708, J709, J710 or J717. See the solid lines in the
figure below.
• RW-00136 on the upper entrances: max. two lines through the wiring clamps
(C) to (E) to two of connectors J708, or J710.
Cable for Control Unit
TB711
TB712
(A)(A)
(B)(B)
Sub monitor cable (RW-4864/00136)
Sub monitor cable (RW-4864)
To Next Page
Loading...
