Furuno FAR-2238S-NXT-BB - Page 12

SYSTEM CONFIGURATION
x
Interswitch connection
When multiple radars are used, connect units as shown in the figure below. This configuration lets
each radar function as a standalone radar in case of HUB malfunction.
RPU-025
PROCESSOR
UNIT
Control Unit
RCU-014/RCU-015/RCU-031
Control Unit RCU-014
Control Unit RCU-015
Control Unit RCU-016
(Max. 2)
Control Unit RCU-014
Control Unit RCU-015
Control Unit RCU-016
(Max. 2)
Select one
Select one
HDG, AIS (IEC 61162-2)
GPS, LOG, AMS, ECDIS
(IEC 61162-1)
VDR
Switching
HUB
HUB-100
Sensor Network (IEC-61162-450)
Intelligent HUB
HUB-3000*
1
or
Switching HUB
HUB-100*
2
ANTENNA UNIT
TRANSCEIVER UNIT
LAN
LAN1
100-115/220-230 VAC
(for de-icer)
Sub Monitor
Gateway network
equipment
(Radar, ECDIS, etc.)
Serial
LAN2LAN2
- Digital Out×6
(Power fail/system
fail/NO×2.NC×2)
- Digital in (ACK in)
HDG, AIS (IEC 61162-2)
GPS, LOG, AMS, ECDIS
(IEC 61162-1)
- Digital Out×6
(Power fail/system
fail/NO×2.NC×2)
- Digital in (ACK in)
Monitor Unit
MU-190/MU-231/MU-270W
(or equivalent for -BB model)
Monitor Unit
MU-190/MU-231/MU-270W
(or equivalent for -BB model)
Select one
Select one
VDR
RPU-025
PROCESSOR
UNIT
LAN
Serial
LAN1
100-115/220-230 VAC
(for de-icer)
Sub Monitor
100-230 VAC or 24 VDC100-230 VAC or 24 VDC
ANTENNA UNIT
TRANSCEIVER UNIT
Solid lines indicate standard supply equipment. Dashed lines indicate optional or local supply equipment.
Control Unit
RCU-016
Control Unit
RCU-016
*
1
: Connect HUB-3000
when more than three
radars or an ECDIS
(FMD) are connected
in the network.
*
2
: When more than two
radars are connected,
the HUB-100 is
available.
Control Unit
RCU-014/RCU-015/RCU-031